SMART TUNER SMT6 - AS A STAND ALONEIGNITION SYSTEM APPLICATION
|
Perfect Power Application Notes. |
Application Note : AN 3.5 |
Introduction
This application note describes how to install an SMT6 as a stand-alone ignition system.Applications
The SMT6 can be set up in two different applications.- A four cylinder, waster spark system. If you wanted to run a four cylinder wasted spark engine you would need to run a 60-2 wheel, and
- A single coil and distributor application, you would need a single pulse input and output.
On both applications, you can set a dwell time and a rev limiter.
Wasted Spark Application Diagram
Single Coil Application Diagram

If using the Wasted Spark Application, you will need to switch "ON" the "Multi Coils" option in the "System Config" screen in the SMT6 Windows Tuning Software :

Conclusion
Although we do not advise that the SMT6 is used in a Stand-Alone application, this is still possible. Please remember that the SMT6 unit has been designed to be a "piggy-back" unit and not a full stand-alone system. The SMT6's capabilities are limited in a stand-alone system.